Cisco (200-301) Exam Questions And Answers page 8

Correct Answer:

• Cost

Explanation:

Correct Answer:

• lldp reinit 5

Explanation:

References:

• https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3560/software/release/12-2_55_se/configuration/guide/3560_scg/swlldp.html

Correct Answer:

• Platinum

Explanation:

References:

• https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_01010111.html

Correct Answer:

• show interfaces summary

Explanation:

The show interfaces summary command will produce the given output. This command provides a summarized view of all interfaces configured on a device.
The show interfaces command is incorrect because this command does not produce the displayed output. This command is used to view information regarding statistics for specific interfaces. Without specifying an interface, a section for each interface will display, as in the example below for FastEthernet0:

The show interfaces serial fast-ethernet command is incorrect because this is not a valid Cisco IOS command.
The show interfaces fast-ethernet 0/0 command is incorrect. Although it produces similar output, that output only relates to the FastEthernet 0/0 interface. An example of this output follows:

Notice that the line of output that says FastEthernet0 is up, line protocol is up indicates that Layers 1 to 3 of the OSI Model are functioning correctly. Also, in the lower portion, there are no values in the error counters such as input errors, output errors, and so on. Finally, make note in line 8 where the interface is set to autosense both the duplex and the speed. Duplex and speed must be in agreement between the NIC on the host and the switch port.
Objective:
Routing Fundamentals
Sub-Objective:
Troubleshoot basic Layer 3 end-to-end connectivity issues
Cisco > Cisco IOS Interface and Hardware Component Command Reference > show interfaces summary

Correct Answers:

• The glass core component is encased in a cladding
• Light is transmitted through the core of the fiber

Explanation:

Correct Answer:

• This is an EIGRP route

Explanation:

The letter D indicates that it was a route learned by the EIGRP routing protocol. In the output of the show ip route command, each route will have a letter next to it that indicates the method by which the route was learned. At the beginning of the output will be a legend describing the letters as shown below:

The letter does not indicate that it is a default route. The default route (if configured) will appear at the end of the legend as follows:
Gateway of last resort is 10.119.254.240 to network 10.140.0.0

The letter does not indicate that it is a static route. Static routes will have an "S" next to them.
The letter does not indicate that it is a directly connected route. Directly connected routes will have a "C" next to them.
Objective:
Routing Fundamentals
Sub-Objective:
Interpret the components of routing table
Cisco > Support > Cisco IOS IP Routing: Protocol-Independent Command Reference > show ip route