Cisco (300-410-ENARSI) Exam Questions And Answers page 1
A customer reports to the support desk that they cannot print from their PC to the local printer id:123456789.
Which tool must be used to diagnose the issue using Cisco DNA Center Assurance?
Which tool must be used to diagnose the issue using Cisco DNA Center Assurance?
ACL trace
path trace
application trace
Infrastructure Security and Services
Infrastructure Services
A DMVPN single hub topology is using IPsec + mGRE with OSPF.
What should be configured on the hub to ensure it will be the designated router?
What should be configured on the hub to ensure it will be the designated router?
route map to set the metrics of learned routes to 110
tunnel interface of the hub with ip nhrp ospf dr
OSPF priority to 0
OSPF priority greater than 1
Layer 3 Technologies
Infrastructure Security and Services
After an associate configured a DMVPN hub, you execute the following command on the hub router:
Which of the following statements is true of this output?
Which of the following statements is true of this output?
The NMBA address was statically configured
The NHRP information did not come from the NHS
The mapping was created through an NHRP registration request
The device at 10.1.1.2 is behind a NAT router
Layer 3 Technologies
VPN Technologies
After some changes in the routing policy, it is noticed that the router in AS 45123 is being used as a transit AS router for several service providers.
Which configuration ensures that the branch router in AS 45123 advertises only the local networks to all SP neighbors?
Which configuration ensures that the branch router in AS 45123 advertises only the local networks to all SP neighbors?
Layer 3 Technologies
Infrastructure Services
An associate creates the following access list that she plans to apply to an interface on a router:
access-list 100 permit ip any any log
What type of traffic could cause this ACL to place a heavy load on the CPU of the router, and what command could be used to reduce the impact of the ACL? (Choose two.)
access-list 100 permit ip any any log
What type of traffic could cause this ACL to place a heavy load on the CPU of the router, and what command could be used to reduce the impact of the ACL? (Choose two.)
traffic that is CEF switched
traffic that is process switched
traffic that is fast switched
ip access-list log-update threshold
ip access-list logging interval
logging rate limit
Layer 3 Technologies
Infrastructure Security and Services
An associate of yours configured a PPPoE connection. You have been alerted by a vulnerability tester that by using a sniffer, he was able to learn the connection credentials.
What type of authentication must your associate have configured on the connection?
What type of authentication must your associate have configured on the connection?
PAP
802.1x
CHAP
IPsec
Layer 3 Technologies
VPN Technologies
An automatic IPv4-compatible IPv6 tunnel exists between two IPv6 networks. The two IPv6 networks belong to different BGP autonomous systems (AS). The tunnel source has the IPv4 address 172.168.111.65/24 and the tunnel destination has the IPv4 address 172.168.222.80/24.
Which of the following statements is TRUE about the tunnel source and tunnel destination IPv6 addresses? (Choose two.)
Which of the following statements is TRUE about the tunnel source and tunnel destination IPv6 addresses? (Choose two.)
the IPv6 address of the tunnel source is 172.168.111.65::
the IPv6 address of the tunnel source is ::172.168.111.65
the IPv6 address of the tunnel destination is 172.168.222.80::
the IPv6 address of the tunnel destination is ::172.168.222.80
Layer 3 Technologies
VPN Technologies
A neighboring EIGRP router fails. Its advertised distance (AD) to network 10.10.10.0 was 2 and the feasible distance (FD) was 3.
Which route will be used to route packets destined for network 10.10.10.0 if the other routes have the following feasible and advertised distances respectively to the destination network?
Which route will be used to route packets destined for network 10.10.10.0 if the other routes have the following feasible and advertised distances respectively to the destination network?
FD-6
AD-3
AD-3
FD-4
AD-1
AD-1
FD-5
AD-3
AD-3
FD-4
AD-3
AD-3
Layer 3 Technologies
An EIGRP network is configured with default settings for all the routers, shown in the exhibit. Traffic is not routing correctly.
What commands need to be run, and on which router should it be run?
What commands need to be run, and on which router should it be run?
The ip summary-address eigrp 500 172.16.0.0.0 255.255.0.0 command should be run on Router D.
The ip summary-address eigrp 500 172.16.3.0.0 255.255.255.0 command should be run on Router C.
The no auto-summary command should be run on Routers A, B, C and F
The auto-summary command should be run on Router D.
Layer 3 Technologies
Infrastructure Services
An engineer configured a Cisco router to send reliable and encrypted notifications for any events to the management server. It was noticed that the notification messages are reliable but not encrypted.
Which action resolves the issue?
Which action resolves the issue?
Configure all devices for SNMPv3 informs with auth.
Configure all devices for SNMPv3 informs with priv.
Configure all devices for SNMPv3 traps with auth.
Configure all devices for SNMPv3 traps with priv.
Layer 3 Technologies
VPN Technologies
Comments