Cisco (300-410-ENARSI) Exam Questions And Answers page 6
Refer to the exhibit. An engineer is troubleshooting BGP on a device but discovers that the clock on the device does not correspond to the time stamp of the log entries.
Which action ensures consistency between the two times?
Layer 3 Technologies
Infrastructure Security and Services
Refer to the exhibit. Why is user authentication being rejected?
Architecture
Infrastructure Security and Services
Refer to the exhibit. While monitoring VTY access to a router, an engineer notices that the router does not have any filter and anyone can access the router with username and password even though an ACL is configured.
Which command resolves this issue?
Layer 3 Technologies
Infrastructure Security and Services
Refer to the exhibit. When monitoring an IPv6 access list, an engineer notices that the ACL does not have any hits and is causing unnecessary traffic through the interface
Which command must be configured to resolve the issue?
Layer 3 Technologies
Infrastructure Automation
Refer to the exhibit. An engineer configures the router 10.1.100.10 for EIGRP autosummarization so that R1 should receive the summary route of 10.0.0.0/8. However, R1 receives more specific /24 routes.
Which action resolves this issue?
Architecture
Layer 3 Technologies
Refer to the exhibit. A network administrator enables DHCP snooping on the Cisco Catalyst 3750-X switch and configures the uplink port (Port-channel2) as a trusted port. Clients are not receiving an IP address, but when DHCP snooping is disabled, clients start receiving IP addresses.
Which global command resolves the issue?
Layer 3 Technologies
Infrastructure Security and Services
Refer to the exhibit. The R1 and R2 configurations are:
The neighbor relationship is not coming up.
Which two sets of configurations bring the neighbors up? (Choose two.)
Layer 3 Technologies
Infrastructure Security and Services
Refer to the exhibit. A network administrator is using the DNA Assurance Dashboard panel to troubleshoot an OSPF adjacency that failed between Edge_NYC Interface GigabitEthernet1/3 with Neighbor Edge_SNJ. The administrator observes that the neighborship is stuck in the exstart state.
How does the administrator fix this issue?
Layer 3 Technologies
Refer to the exhibit. An IT staff member comes into the office during normal office hours and cannot access devices through SSH.
Which action should be taken to resolve this issue?
Layer 3 Technologies
Infrastructure Security and Services
Refer to the exhibit. An administrator that is connected to the console does not see debug messages when remote users log in.
Which action ensures that debug messages are displayed for remote logins?
Layer 3 Technologies
Infrastructure Security and Services
Comments