Exam Logo

Cisco (300-420-ENSLD) Exam Questions And Answers page 25


Refer to the exhibit. The full EIGRP routing table is advertised throughout the network. Currently, users experience data loss when any one link in the network fails. An architect must optimize the network to reduce the impact when a link fails. Which solution should the architect include in the design?
Design Advanced Addressing and Routing Solutions Design WAN for Enterprise Networks
A global organization with several branches hired a network architect to design an overlay VPN solution. The branches communicate with each other frequently. The customer expects to add more branches in the future. To meet the customer s security requirements, the architect plans to provide traffic protection using dynamic IPsec tunnels. Which solution should the architect choose?
Design Advanced Addressing and Routing Solutions Design WAN for Enterprise Networks
An engineer is designing an EIGRP network for a small branch office site where there is only one Layer 3 router. The engineer wants the router to advertise the local LAN network to remote EIGRP neighbors without sending any unnecessary multicast messages on the local LAN. Which action should the engineer take?
Design Advanced Addressing and Routing Solutions Design Network Services for Enterprise Networks

Refer to the exhibit. An architect is designing a BGP solution to connect a remote branch to a service provider. There are several prefixes within the branch that the company does not want to be advertised to the Internet. Which solution should the architect use to accomplish this?
Design Advanced Addressing and Routing Solutions Design WAN for Enterprise Networks

Refer to the exhibit. AS65533 and AS65530 are announcing a partial Internet routing table as well as their IP subnets. An architect must create a design that ensures AS64512 does not become a transit AS. Which filtering solution must the architect choose?
Design Advanced Addressing and Routing Solutions Design WAN for Enterprise Networks
Which of the following capabilities does a multilayer switch possess that an Access layer switch does not? (Choose all that apply.)
Design Advanced Addressing and Routing Solutions Design Advanced Enterprise Campus Networks
You are troubleshooting a problem with two routers configured in a HSRP group. You intended to configure the routers so that Router A and Router B would each track their respective Fa0/1 interfaces and decrement their priorities for several VLAN groups if the tracked interface went down. However, you find that Router A is not taking over as the active device for the HSRP group on VLAN 101 when the Fa0/1 interface on Router B fails.

Which command would NOT be useful for discovering the problem?
Design Advanced Addressing and Routing Solutions Design Security Services