Cisco (300-425-ENWLSD) Exam Questions And Answers page 2
Refer to the exhibit. A client roams between two APs that are registered to two different controllers, where each controller has an interface in the client subnet. Both controllers are running AireOS. Which scenario explains the client roaming behavior?
Wireless Design Principles
Wireless Security Design
During a wireless design all APs are mapped to designated controllers in case of a failure. The controllers are located in the same data center but in different racks. An AP failed over to a controller that was not defined on its High Availability tab. The customer does not want the AP to move back to its defined Cisco WLCs until they manually intervene. What needs to be addressed in the design?
Wireless Design Principles
Cisco Enterprise Wireless Network Design
A customer called with a requirement that internal clients must be on different subnets depending on the building they are in. All APs are operating in local mode and will not be modified, and this is a single controller solution. Which design approach creates the desired result?
Cisco Enterprise Wireless Network Design
Wireless Security Design
What causes the most signal attenuation, based on the wireless design tools?
Wireless Design Principles
Wireless Security Design
Where must the APs be mounted when used in a high-density wireless network to provide 6 dB to 20 dB of attenuation to a cell?
WLAN Deployment
WLAN High-Density Design
An engineer has performed a predictive site survey for high-speed data and voice in an indoor office. What is the recommended data rate with "67 dBm signal level for optimal VoWLAN design?
WLAN Deployment
WLAN High-Density Design
Clustering Cisco WLCs into a single RF group enables the RRM algorithms to scale beyond the capabilities of a single Cisco WLC. How many WLCs and APs in an RF group can the controller software scale up to in WLC release 8.9 depending on the platform?
Wireless Design Principles
Cisco Enterprise Wireless Network Design
A wireless engineer is designing a wireless network to support real time applications over wireless. Which IEEE protocol must the engineer enable on the WLC so that the number of packets that are exchanged between an access point and client are reduced and fast roaming occurs?
Wireless Design Principles
Wireless Security Design
A wireless engineer is designing a wireless network to support real time applications over wireless. Which IEEE protocol must the engineer enable on the WLC so that neighbor list radio management packets are sent to the wireless devices?
Wireless Design Principles
Wireless Security Design
An engineer must configure the virtual IP address on multiple controllers in a mobility group. Which rule must the engineer follow to ensure proper roaming?
Wireless Design Principles
Wireless Security Design
Comments