Cisco (300-425-ENWLSD) Exam Questions And Answers page 7
Refer to the exhibit. During a post Mesh deployment survey, an engineer notices that frame collisions occur when MAP-1 and MAP-3 talk to RAP-2. Which type of issue does the engineer need to address in the design?
WLAN Deployment
Wireless Security Design
A wireless engineer is designing a wireless network for a warehouse using access points with internal antennas. Which two elements have a negative effect on the wireless users? (Choose two.)
WLAN Deployment
Wireless Security Design
An engineer is reducing the subnet size of the corporate WLAN by segmenting the VLAN into smaller subnets. Clients will be assigned a subnet by location. Which type of groups should the engineer use to map the smaller subnets to the corporate WLAN?
WLAN Deployment
WLAN Location Services
A wireless engineer must optimize RF performance for multiple buildings with multiple types of construction and user density. Which two actions must be taken? (Choose two.)
Wireless Design Principles
WLAN Deployment
An enterprise is using two wireless controllers to support the wireless network. The data center is located in the head office. Each controller has a corporate WLAN configured with the name Copr-NET392267230WLC-1 and Corp-NET68371638WLC-2. The APs are installed using a round-robin approach to load balance the traffic. What should be changed on the cofiguration to optimize roaming?
Cisco Enterprise Wireless Network Design
WLAN Deployment
WLC SSO is set up between two WLCs in a service provider network serving public spaces. On WLC failover, it is noticed that only about half of the original client count is now showing on the secondary WLC, although it is currently showing the role as active. Which design side case explains the issue?
Wireless Design Principles
Wireless Security Design
A customer is concerned about mesh backhaul link security. Which level of encryption does the backhaul link use?
Cisco Enterprise Wireless Network Design
Wireless Security Design
APs in a remote office recently have been converted from local mode to FlexConnect to take advantage of the local switching. After the change, remote wireless users report voice quality issues and bad quality on wireless IP phones while roaming. A debug is performed, and it is noticed that the 802.11r Fast Transition is not working as expected, like on local mode AP, though the same WLAN configuration is in place. What is the cause of the issue regarding the FlexConnect APs?
Wireless Design Principles
Wireless Security Design
An engineer must decide the cell overlap for a wireless voice deployment. Which Cisco measurement recommendation should be considered?
Wireless Design Principles
WLAN Deployment
Which UDP port numbers are used for exchange mobility packets in an AireOS wireless deployment?
Wireless Design Principles
Wireless Security Design
Comments