Cisco (300-510-SPRI) Exam Questions And Answers page 6

Which cost is the default when redistributing routes from BGP to OSPF?

Refer to the exhibit. An engineer is troubleshooting an OSPF issue. Router 1 has a neighbor relationship with router 2. Only router 1 classful EIGRP routes can be seen on router 2. In order for all EIGRP routes to be redistributed correctly, which action should be taken?

Refer to the exhibit. After you applied these configurations to routers R1 and R2, the two devices could not form a neighbor relationship. Which reason for the problem is the most likely?

Refer to the exhibit.


The extension header of the IPv6 header is ignored when which value is equal to zero?

Refer to the exhibit.



VPN users that are connected to PE routers are facing network issues. Traffic that originates from CE1 drops before reaching CE2. An engineer finds no outgoing traffic statistics on PE1 and PE2 routers toward CE devices and finds that the PE1 router is running the older software image. Which action must be implemented to resolve the issues?

For which reason do you deploy BGP confederations within a BGP transit backbone?

After an engineer configures BGP in R1, it starts receiving this message:


Which action makes the peering come back up again?

Refer to the exhibit. A service provider technician is working on a multicast issue for a customer. While checking the multicast table, the technician notices that no flags are present for the (1.1.1.1, 239.1.1.1) entry, yet flags are present for the (1.1.1.1, 232.1.1.1) entry.

Which factor might explain this issue?

Refer to the exhibit. Which two commands must the engineer configure for the company s PIM-SM network to enable Auto-RP mappings to be sent over the FastEthernet0/0 interface, without affecting normal operation? (Choose two.)

Refer to the exhibit.


The extension header of the IPv6 header is ignored when which value is equal to zero?