Cisco (300-610-DCID) Exam Questions And Answers page 12
An engineer must deploy a Cisco HyperFlex system at two data centers. For redundancy reasons, the setup must achieve data protection in case of an entire site failure. The data must be available on both sites at all times to keep the recovery time objective to a minimum.
Which Cisco HyperFlex deployment model meets these requirements?
Which Cisco HyperFlex deployment model meets these requirements?
Data Center Infrastructure Design
Data Center Infrastructure Security Design
A failure occurs on the network between two BFD and OSPF neighbors. Drag and drop the protocol actions from the left into the correct order on the right.
Data Center Network Services Design
Refer to the exhibit.
A Cisco UCS chassis that has two IOMs is discovered. The chassis discovery policy creates a fabric port channel.
What is the result of this policy?
A Cisco UCS chassis that has two IOMs is discovered. The chassis discovery policy creates a fabric port channel.
What is the result of this policy?
Data Center Compute Connectivity Design
A company has added a new FCoE storage array to increase the performance of datastore access for end users. This storage array is directly connected to the Cisco Nexus 5672UP switches using four 10G port-channel interfaces. After deployment, the end users fail to access the datastore compared to the older solution. A network engineer verified the port-channel interface and finds that the congestion occurs when PFC frames are generated at the FCoE ingress interface. Which action must be taken to resolve the congestion issue?
Data Center Storage Connectivity Design
Data Center Network Services Design
When planning to deploy a load-balancing service as a managed node, which ACI configuration must be included?
Data Center Network Services Design
An engineer must configure an interface for managing and orchestrating a Cisco Nexus device. The interface must be operational if the data and control planes crash, support IPv4 and IPv6 addressing, and have access to its own VRF instance.
Which interface should be used to meet these requirements?
Which interface should be used to meet these requirements?
Data Center Automation and Orchestration Design
Which mode must be enabled on a Cisco UCS Fabric Interconnect to connect directly to a storage array?
Data Center Storage Connectivity Design
An engineer must choose the World Wide Port Name for the Cisco UCS Fibre Channel virtual host bus adapter.
Which identifier must be used?
Which identifier must be used?
Data Center Compute Connectivity Design
Refer to the exhibit.
A high-availability setup for iSCSI is designed with the host running iSCSI multipath software. Each IP storage port on the MDS switch exports the same two Fibre Channel target ports with different iSCSI target names.
In this design, how many iSCSI sessions are created from the host so that recovery occurs if any component fails?
A high-availability setup for iSCSI is designed with the host running iSCSI multipath software. Each IP storage port on the MDS switch exports the same two Fibre Channel target ports with different iSCSI target names.
In this design, how many iSCSI sessions are created from the host so that recovery occurs if any component fails?
Data Center Storage Connectivity Design
Data Center Network Services Design
A network architect designs the iSCSI-based storage area network solution. The iSCSI datastore must be designed with high availability, minimal downtime, and no single point of failure. The requirement is to fail over I/O to alternate paths based on SCSI sense codes without reliance on network failures.
Which feature must be deployed to meet these requirements?
Which feature must be deployed to meet these requirements?
Data Center Storage Connectivity Design
Data Center Network Services Design
Comments