Implementing Cisco Application Centric Infrastructure 300-620-DCACI

Cisco (300-620-DCACI) Exam Questions And Answers page 6

How to integrate a Hyperflex storage cluster into a Cisco ACI fabric with vCenter and a vendor-neutral discovery protocol?

Single Choice

A network engineer is integrating a new Hyperflex storage duster into an existing Cisco ACI fabric. The Hyperflex cluster must be managed by vCenter, so a new vSphere Distributed switch must be created. In addition, the hardware discovery must be performed by a vendor-neutral discovery protocol. Which set of steps meets these requirements?

Configure an Interface Policy group, select CDP, and apply it to the desired interfaces.
Enter the vCenter IP and credentials in the Create vCenter Controller dialog box.
In the Create VMware VMM domain dialog box, select Read-Only Mode.

Configure an Interface Policy group, select LLDP, and apply it to the selected interfaces.
Create a VLAN pool, add it to the VMware VMM domain, and include the appropriate interfaces.
Enter the vCenter IP and credentials in the Create vCenter Controller dialog box.

Configure a Switch Policy group, select LLDP, and apply it to the indicated interfaces.
Set up a VMware VMM domain and apply it to the appropriate interfaces.
Enter the APIC management IP and credentials in the Create vCenter Controller dialog box.

Configure an Interface Policy group, select CDP, and apply it to the designated interfaces.
Create a VMware VMM domain, add it to the VLAN pool, and associate it to the designated interfaces.
Select Read Only Mode in the Create VMware VMM domain dialog box.

ACI Fabric Access Policies ACI Tenant Policies

Which import mode in the configuration import policy ensures termination if the imported configuration is incompatible?

Single Choice

An engineer is creating a configuration import policy that must terminate if the imported configuration is incompatible with the existing system. Which import mode achieves this result?

merge

atomic

best effort

replace

ACI Fabric Access Policies ACI Fabric Automation

What is required in the bridge domain for endpoint table to learn IP addresses?

Single Choice

What must be enabled in the bridge domain to have the endpoint table learn the IP addresses of endpoints?

L2 unknown unicast: flood

GARP based detection

unicast routing

subnet scope

ACI Fabric Access Policies ACI Application Network Profiles

How to prevent Layer 2 loops in a Cisco ACI fabric and connect a new host to Leaf 101?

Single Choice

An engineer must connect a new host to port 1/1 on Leaf 101. A Cisco ACI fabric has an MCP policy configured but experiences excessive Layer 2 loops. The engineer wants the Cisco ACI fabric to detect and prevent Layer 2 loops in the fabric. Which set of actions accomplishes these goals?

Enable MCP locally.
Associate the MCP policy with an interface policy group.

Enable MCP locally.
Associate the MCP policy with an interface profile.

Enable MCP globally.
Associate the MCP policy with an interface selector.

Enable MCP globally.
Associate the MCP policy with an interface policy group.

ACI Fabric Access Policies ACI Fabric Connectivity Policies

What is the endpoint learning operation on the ingress leaf switch for traffic from a Layer 3 Out?

Single Choice

Which endpoint learning operation is completed on the ingress leaf switch when traffic is received from a Layer 3 Out?

The source MAC address of the traffic is learned as a local endpoint.

The source MAC address of the traffic is learned as a remote endpoint.

The source IP address of the traffic is learned as a remote endpoint.

The source IP address of the traffic is learned as a local endpoint.

ACI Fabric Access Policies ACI Fabric Connectivity Policies

How can the requirement for out-of-band management of NTP protocol on leaf and spine switches be achieved?

Single Choice

In-band is currently configured and used to manage the Cisco ACI fabric. The requirement is for leaf and spine switches to use out-of-band management for NTP protocol. Which action accomplishes this goal?

Select Out-of-Band as Management EPG in the default DateTimePolicy.

Create an Override Policy with NTP Out-of-Band for leaf and spine switches.

Change the interface used for APIC external connectivity to ooband.

Add a new filter to the utilized Out-of-Band-Contract to allow NTP protocol.

ACI Fabric Access Policies ACI Fabric Connectivity Policies

How to break the STP loop between switch1 and switch2 in a Cisco ACI environment?

Single Choice

Refer to the exhibit. An engineer is deploying a Cisco ACI environment but experiences a STP loop between switch1 and switch2. Which configuration step is needed to break the STP loop?

Configure a Layer 2 external bridged network on the interfaces facing the MST switches.

Enable the native VLAN on the interfaces facing the MST switches using static ports in a dedicated EPG.

Enable BPDU filter under the STP interface policy on the interfaces facing the MST switches.

Configure the STP instance to VLAN mapping under the switch STP policy.

ACI Fabric Access Policies ACI Fabric Connectivity Policies

What is the true statement about ACI Multi-Pod and TEP pool?

Single Choice

Which statement regarding ACI Multi-Pod and TEP pool is true?

The IP addresses used in the IPN network can overlap TEP pool of the APIC.

A different TEP pool must be assigned to each Pod.

The Pod1 TEP pool must be split and a portion of the TEP pool allocated to each Pod.

The same TEP pool is used in all Pods.

ACI Fabric Access Policies ACI Fabric Connectivity Policies

What Adjacency Type value should be used for client endpoint and service node interface in different subnets?

Single Choice

Refer to the exhibit. Which Adjacency Type value should be set when the client endpoint and the service node interface are in a different subnet?

Routed

Unicast

L3Out

ACI Fabric Connectivity Policies ACI Fabric Automation

What type of profile is required for deploying an access port policy group?

Single Choice

Which type of profile needs to be created to deploy an access port policy group?

attachable entity

Pod

module

leaf interface

ACI Fabric Access Policies ACI Fabric Connectivity Policies

Previous Questions

Next Questions

Cisco (300-620-DCACI) Exam Questions And Answers page 6

How to integrate a Hyperflex storage cluster into a Cisco ACI fabric with vCenter and a vendor-neutral discovery protocol?

Comments

Which import mode in the configuration import policy ensures termination if the imported configuration is incompatible?

Correct Answer:

References:

Comments

What is required in the bridge domain for endpoint table to learn IP addresses?

Correct Answer:

References:

Comments

How to prevent Layer 2 loops in a Cisco ACI fabric and connect a new host to Leaf 101?

Comments

What is the endpoint learning operation on the ingress leaf switch for traffic from a Layer 3 Out?

Comments

How can the requirement for out-of-band management of NTP protocol on leaf and spine switches be achieved?

Comments

How to break the STP loop between switch1 and switch2 in a Cisco ACI environment?

Comments

What is the true statement about ACI Multi-Pod and TEP pool?

Correct Answer:

References:

Comments

What Adjacency Type value should be used for client endpoint and service node interface in different subnets?

Correct Answer:

Explanation:

Comments

What type of profile is required for deploying an access port policy group?

Correct Answer:

References:

Comments

{{ exam.shortName }}

{{ exam.longName }}