Cisco (350-501-SPCOR) Exam Questions And Answers page 12
Which additional configuration is required for NetFlow to provide traceback information?
The BGP routing process must be started for any ingress or egress data to be reported when using NetFlow Version 5.
Cisco Express Forwarding must be configured for traffic that is egressing from the router to be property reported.
LLDP must be configured or the device will be unable to locate a NetFlow analyzer.
Routing Technologies
Services
Which CLI mode must be used to configure the BGP keychain in Cisco IOS XR Software?
routing configuration mode
BGP neighbor configuration mode
global configuration mode
BGP address-family configuration mode
Transport Technologies
Routing Technologies
Which configuration enables BGP FlowSpec client function and installation of policies on all local interfaces?
flowspec
address-family ipv4
local-install interface-all
address-family ipv4
local-install interface-all
flowspec
address-family ipv4
install interface-all local
address-family ipv4
install interface-all local
flowspec
address-family ipv4
install interface-all
address-family ipv4
install interface-all
flowspec
address-family ipv4
local-install all-interface
address-family ipv4
local-install all-interface
Transport Technologies
Routing Technologies
Which configuration mode do you use to apply the mpls ldp graceful-restart command in IOS XE Software?
MPLS LDP neighbor
interface
MPLS
global
Routing Technologies
Services
Which configuration modifies Local Packet Transport Services hardware policies?
Routing Technologies
Services
Which MPLS design attribute can you use to provide Internet access to a major customer through a separate dedicated VPN?
The Internet gateway router is connected as a PE router to the MPLS backbone.
The CE router supports VRF-Lite and the full BGP routing table.
The Internet gateway inserts the full Internet BGP routing table into the Internet access VPN.
The customer that needs the Internet access service is assigned to the same RTs as the Internet gateway.
Routing Technologies
VPN Technologies
Which protocol is used for communication between the PCE and PCC?
POP
CEF
PCEP
ICMP
Routing Technologies
Services
Which QoS model allows hosts to report their QoS needs to the network?
IntServ
CB-WFQ
DiffServ
MQC
Services
Automation and Assurance
Which statement about segment routing prefix segments is true?
It is the longest path to a node.
It is linked to an adjacency SID that is globally unique within the router.
It is linked to a prefix SID that is globally unique within segment routing domain.
It requires using EIGRP to operate.
Architecture
Routing Technologies
Which two actions describe LSP delegation to PCE servers? (Choose two.)
removing TE re-optimization timer timeouts
changing the precedence of any of the PCE servers
entering the mpls traffic-eng reoptimize command
adding a new PCE server with lower precedence than the primary PCE
adding a new PCE server with higher precedence than the primary PCE
Routing Technologies
VPN Technologies
Comments