Cisco (350-501-SPCOR) Exam Questions And Answers page 6
Refer to the exhibit. A network operator recently configured BGP FlowSpec for the internal IT network. What will be inferred from the configuration deployed on the network?
The policy is configured locally on CSR1 and currently has no active traffic
The policy is learned via BGP FlowSpec and drops all traffic for TCP ports 80 and 443
The policy is learned via BGP FlowSpec and has active traffic
Architecture
Services
Refer to the exhibit. An engineer is reviewing the BGP configuration. Which routes must be advertised to 10.10.10.1?
Local routes are permitted, and routes from other ASNs are denied.
All routes whether local or from other ASNs are denied.
Local routes are denied, and routes from other ASNs are permitted.
All routes whether local or from other ASNs are permitted.
Routing Technologies
Services
Refer to the exhibit. Which show command should be implemented to display per-interface statistics about uRPF drops and suppressed drops?
show cef interface
show ip traffic
show ip interface
show ip interface brief
Routing Technologies
Services
Refer to the exhibits. R1 and R2 are directly connected and IS-IS routing has been enabled between R1 and R2. R1 generates the above log message periodically.
Based on this output, which statement is true?
IS-IS neighbor authentication is failing for Level 2 PDUs only.
IS-IS neighbor authentication is failing for Level 2 first and then for Level 1 PDUs.
IS-IS neighbor authentication is failing for Level 1 and Level 2 PDUs.
IS-IS neighbor authentication is failing for Level 1 PDUs only.
Architecture
Routing Technologies
Refer to the exhibit. An engineer is updating this network to meet these conditions:
• Area 10 will receive inter-area routes and support mutual redistribution of external routes with the extranet.
• The ::/0 route is prohibited in Area 10.
• Area 11 will receive only the ::/0 route from the ABR.
• External route redistribution is not supported in Area 11.
• The ABR in Area 11 will advertise no interarea routes.
Which two configurations must be performed to meet the requirements? (Choose two.)
Configure area 10 as nssa on R9 and XR32
Configure area 11 as stub no-summary on R7 and as stub on XR31
Configure area 11 as nssa no-summary on R7 and as nssa on XR31
Configure area 11 as nssa default-information-originate on R7 and as nssa on XR31
Configure area 10 as stub on R9 and XR32
Architecture
Routing Technologies
Refer to the exhibit. With which router does IOSXRV-1 have LDP session protection capability enabled but session hold up is not active?
192.168.0.4
192.168.0.5
192.168.0.1
192.168.0.3
Architecture
Routing Technologies
Refer to the exhibit. Assume all other configurations are correct and the network is otherwise operating normally.
Which conclusion can you draw about the neighbor relationship between routers R1 and R2?
The neighbor relationship is up.
The neighbor relationship will be up only if the two devices have activated the correct neighbor relationships under the IPv4 address family.
The neighbor is down because the local-as value for R2 is missing in the R1 neighbor statement.
The neighbor relationship is down because R1 believes R2 is in AS 65012.
Architecture
Routing Technologies
Refer to the exhibit. An engineer is trying to implement BGP configuration on a router. Which configuration error prevents the ASBR from establishing a BGP neighborship to a directly connected BGP speaker?
The routing policy is absent for this Cisco IOS XR eBGP instance.
The TCP session parameters are not specified.
The VPNv4 address family interferes with the BGP IPv4 address family negotiations.
The IPv4 address family configuration under neighbor configuration-mode must be removed.
Architecture
Routing Technologies
Refer to the exhibit. If router RA is configured as shown, which IPv4 multicast address space does it use?
224.0.0.0/8
225.0.0.0/8
232.0.0.0/8
239.0.0.0/8
Routing Technologies
Services
Refer to the exhibit. An engineer configured multicast routing on client s network. What is the effect of this multicast implementation?
R2 is unable to share information because the ip pim autorp listener command is missing
R1 floods information about R2 throughout the multicast domain
R2 floods information about R1 throughout the multicast domain
R2 is elected as the RP for this domain
Routing Technologies
VPN Technologies
Comments