Cisco (350-601-DCCOR) Exam Questions And Answers page 1
The EPLD update of the supervisor module has been scheduled for several Cisco MDS 9000 Series Switches. What will be the impact of the update?
The redundant supervisor takes over while the EPLD update is in progress and the switch is rebooted after the upgrade is completed.
All control plane traffic is stopped for the duration of the EPLD update and the switch remains operational for the duration of the upgrade.
The redundant supervisor takes over while the EPLD update is in progress and there is no service disruption.
Storage Networking
Security
Refer to the exhibit.
An engineer is implementing zoning on two Cisco MDS switches. After the implementation is finished, E Ports that connect the two Cisco MDS switches become isolated.
What is wrong with the implementation?
An engineer is implementing zoning on two Cisco MDS switches. After the implementation is finished, E Ports that connect the two Cisco MDS switches become isolated.
What is wrong with the implementation?
Zones are local to the MDS switch and name service must be used to activate the connection between E Ports.
Different zone set names must be configured on both MDS switches.
Zones must have the same name on both MDS switches for the E Ports to function.
E Ports on both MDS switches must be configured as F Ports for the zoning to function.
Network Virtualization
Storage Networking
Which adjacency server configuration makes two OTV edge devices located in the same site bring up the dual-site adjacency?
Network Virtualization
Security
An engineer evaluates a UI-based infrastructure management system capable of monitoring and deploying standalone VXLAN BGP EVPN deployments. The storage administrators also need the solution to manage the Cisco MDS 9000 Series Switches. Which solution meets these requirements?
Cisco DCNM
Cisco Tetration
Cisco UCS Director
Cisco Intersight
Data Center Infrastructure
Network Virtualization
Due to a major version change, an engineer must perform a software upgrade on a Cisco Nexus Series switch.
Which two technologies should be implemented to reduce disruptions to the network during the upgrade? (Choose two.)
Which two technologies should be implemented to reduce disruptions to the network during the upgrade? (Choose two.)
vPC
HSRP
VDC
MLAG
PAgP
Network Virtualization
Security
An engineer updated firmware on Fabric Interconnects and activates it. However, the endpoint fails to boot from the new firmware image. What is expected to occur in this case?
The system defaults to and boots into kickstart image
The system defaults to and boots into GOLD firmware image
The system defaults to the GOLD firmware image
The system defaults to the backup image version
Storage Networking
Security
In an FCoE environment, for which two sets of data must an interface that implements the PAUSE mechanism always provision sufficient ingress buffer? (Choose two.)
frames that were sent with high credit
frames that were sent on the link but not yet received
frames that were processed and transmitted by the transmitter after the PAUSE frame left the sender
frames that were processed and transmitted by the transmitter before the PAUSE frame left the sender
frames that were sent on the link and received
Storage Networking
Security
When deploying a Cisco HyperFlex edge with a pair of switches, what is the minimum number of interfaces in trunk mode required on each HX node?
1
2
4
6
Network Virtualization
Compute
What is a characteristic of the NFS protocol?
Single Choice
What is a characteristic of the NFS protocol?
It uses remote procedure calls with TCP/IP for transport.
It is used for booting Cisco UCS B-Series servers.
It is used to access a storage array at a block level.
It uses UDP and HTTP as its transport.
Storage Networking
Security
Refer to the exhibit.
Why does the Python code for Cisco NX-API print an error message?
Why does the Python code for Cisco NX-API print an error message?
The JSON is not a supported format for the NX-API.
The "type" is wrong in the header of the request and should be "cli_conf"
NX-API does not allow configuration for features via the requests module.
The "type" is wrong in the body of the request and should be "cli_conf"
Automation
Security
Comments