Cisco (350-601-DCCOR) Exam Questions And Answers page 10
An engineer must shut down the Ethernet 1/2 interface when the Ethernet 4/5 interface state is down. Drag and drop the CLI commands from the bottom onto the blanks in the exhibit to implement this EEM. Not all commands are used.
Network Virtualization
Security
Which two actions should be taken before an upgrade is started on a Cisco MDS switch? (Choose two.)
check the impact of the upgrade using the show install all impact command
free up space on the USB3 device by deleting old Cisco NX-OS image files
make the primary supervisor the active supervisor
back up the configuration
Storage Networking
Security
An engineer changed a configuration and must perform a rollback.
Which statement applies to a Cisco Nexus 5600 Series Switch?
Which statement applies to a Cisco Nexus 5600 Series Switch?
The configuration rollback functionality is disabled when FCoE is enabled.
A system checkpoint is generated automatically when the running configuration is saved to NVRAM.
A user who is assigned to the network-operator user role is allowed to perform a rollback.
Errors are skipped when an atomic rollback type is triggered.
Network Virtualization
Compute
An engineer must recover configuration on a Cisco MDS 9000 Series switch from a previous version that was backed up to bootflash and then verify the restoration.
Drag and drop the commands on the left to the correct order on the right.
Drag and drop the commands on the left to the correct order on the right.
Storage Networking
Security
A network administrator must configure an extra keyring in Cisco UCS Manager. The key must provide a high level of encryption and secure authentication when users use the web interface. Which configuration command set must be applied to meet these requirements?
Network Virtualization
Security
What is required for using Puppet in a Cisco NX-OS environment?
OpenNP
XML management interface
NX-API
Open Agent Container
Automation
Security
A network architect must redesign a data center network based on OSPFv2. The network must perform fast reconvergence between directly connected switches. Which two actions must be taken to meet the requirements? (Choose two.)
Set low OSPF hello and DEAD timers.
Configure all links on AREA 0.
Enable BFD for failure detection.
Use OSPF point-to-point links only.
Implement a virtual link between the switches.
Data Center Infrastructure
Network Virtualization
Which statement is true about upgrading the firmware on a Cisco MDS storage switch with dual supervisors?
Supervisors can be upgraded independently to test the new firmware.
The new firmware is loaded on the standby supervisor first.
Both supervisors load the new firmware and then the active supervisor reboots.
The standby supervisor must be offline before the firmware upgrade begins.
Storage Networking
Security
Refer to the exhibit. What is the result of implementing the configuration?
The RADIUS server timeout value is 15 milliseconds.
RADIUS traffic is sourced from the VLAN 200 interface.
Users specify the RADIUS server when they log in.
Only the RADIUS server is used for authentication.
Network Virtualization
Compute
The FCoE technology is used in a data center and the MDS switches are configured as Fibre Channel Forwarders. Which configuration should be applied to an MDS switch in order to be used as the best switch to connect by the CNAs in the fabric?
fcoe fcf-priority 512
fcoe fcf-priority 0
no fcoe fcf-priority
fcoe fcf-priority 1024
Data Center Infrastructure
Storage Networking
Comments