Cisco (350-601-DCCOR) Exam Questions And Answers page 13
What is a benefit of independent resource scaling in Cisco HyperFlex hybrid architecture?
flexible expansion of compute, caching, and capacity
multivendor converged node hardware support
support for compute nodes with third-party storage
Compute
Automation
Refer to the exhibits. ESXi-Server is associated to the blade server. A VLAN is added to Trunk-A. The VLAN is missing on the vNIC of ESXi-Server. Which action should be taken to add the VLAN to the vNIC?
Change the template type of Trunk-A to an updating template.
Remove the VLAN from the Trunk-A template and add the VLAN again.
Change the template type of ESXi-Server to an updating template.
Remove both templates and recreate them as updating templates.
Network Virtualization
Compute
A network engineer needs to upgrade the EPLDs of the fabric modules for a Cisco MDS director-class switch. In which order are components reloaded during the process?
one fabric module at the time
all fabric modules followed by the entire switching platform
all fabric modules in parallel
one module and one supervisor at the time
Network Virtualization
Storage Networking
An engineer must start a software upgrade on a Cisco Nexus 5000 Series Switch during a zone merge. What is the result of this action?
The upgrade stops
The zone merge pauses until the upgrade completes
The zone merge stops
The zone merge executes and then the upgrade completes
Network Virtualization
Security
The Cisco Nexus 5600 Series Switch experiences occasional packet drops on interface ethernet 1/16. An engineer wants to implement a SPAN session to investigate the issue further. The network analyzer to which the packets must be directed is located on interface 1/3. The analyzer is limited on disk space available for traffic capture, so the Cisco Nexus Switch should send only the relevant data. Which two command sets configure the SPAN session that meets these requirements? (Choose two.)
Network Virtualization
Security
Host1 is in VLAN100 located in DataCenter1 and Host2 is in VLAN200 located in DataCenter2.
Which OTV VLAN mapping configuration allows Layer 2 connectivity between these two hosts?
Which OTV VLAN mapping configuration allows Layer 2 connectivity between these two hosts?
Data Center Infrastructure
Network Virtualization
Refer to the exhibit. A host with a source address 10.10.10.10 sends traffic to multicast group 239.1.1.1. How do the vPC switches forward the multicast traffic?
If multicast traffic is received on Switch1 over the vPC peer-link, the traffic is dropped
If multicast traffic is received on Po10 Switch1, the traffic is forwarded out on Po1 and Po20
If multicast traffic is received on Po11 Switch2, the traffic is forwarded out only on Po20
If multicast traffic is received on Po11 Switch2, the traffic is dropped.
Network Virtualization
Storage Networking
An engineer must configure OSPF routing on Cisco Nexus 9000 Series Switches. The IP subnet of the Eth1/2 interfaces for both switches must be advertised via OSPF. However, these interfaces must not establish OSPF adjacency or send routing updates. The current OSPF adjacency over the interfaces Eth1/1 on SW1 and Eth1/1 on SW2 must remain unaffected. Which configuration must be applied to both Nexus switches to meet these requirements?
Network Virtualization
Security
A Cisco UCS C-Series server is installed at a data center. The server should be managed by the Cisco UCS Manager by using a single cable for management and data traffic. Which configuration should be applied after the physical connection is established?
UCS-A# scope server 1
UCS-A /server# scope cimc
UCS-A /server/cimc # scope mgmt-conn sideband
UCS-A /server/cimc # mgmt-conn-state enabled
UCS-A /server/cimc/mgmt-conn* # commit-buffer
UCS-A /server# scope cimc
UCS-A /server/cimc # scope mgmt-conn sideband
UCS-A /server/cimc # mgmt-conn-state enabled
UCS-A /server/cimc/mgmt-conn* # commit-buffer
UCS-A# scope chassis 1
UCS-A /chassis# scope cimc
UCS-A /chassis/cimc # scope mgmt-conn sideband
UCS-A /chassis/cimc/mgmt-conn # mgmt-conn-state enabled
UCS-A /chassis/cimc/mgmt-conn* # commit-buffer
UCS-A /chassis# scope cimc
UCS-A /chassis/cimc # scope mgmt-conn sideband
UCS-A /chassis/cimc/mgmt-conn # mgmt-conn-state enabled
UCS-A /chassis/cimc/mgmt-conn* # commit-buffer
UCS-A# scope chassis 1
UCS-A /chassis# scope cimc
UCS-A /chassis /cimc # set mgmt-conn-state enabled
UCS-A /chassis /cimc/mgmt-conn* # commit-buffer
UCS-A /chassis# scope cimc
UCS-A /chassis /cimc # set mgmt-conn-state enabled
UCS-A /chassis /cimc/mgmt-conn* # commit-buffer
UCS-A# scope server 1
UCS-A /server# scope cimc
UCS-A /server/cimc # scope mgmt-conn sideband
UCS-A /server/cimc/mgmt-conn #set mgmt-conn-state enabled
UCS-A /server/cimc/mgmt-conn* # commit-buffer
UCS-A /server# scope cimc
UCS-A /server/cimc # scope mgmt-conn sideband
UCS-A /server/cimc/mgmt-conn #set mgmt-conn-state enabled
UCS-A /server/cimc/mgmt-conn* # commit-buffer
Data Center Infrastructure
Compute
An engineer requires a solution to automate the configuration and deployment of remote network devices for a customer. The engineer must keep these considerations in mind:
• The customer s environment is based on industry-accepted standards and requires a solution that meets these standards.
• The security requirements mandate the use of a secure transport mechanism between the automation software and target devices such as SSH or TLS.
• The solution must be implemented using a human-readable language and provide the functionality to format data in XML or JSON.
Which solution must be used to meet these requirements?
• The customer s environment is based on industry-accepted standards and requires a solution that meets these standards.
• The security requirements mandate the use of a secure transport mechanism between the automation software and target devices such as SSH or TLS.
• The solution must be implemented using a human-readable language and provide the functionality to format data in XML or JSON.
Which solution must be used to meet these requirements?
Ansible
REST API
NETCONF
SNMP
Automation
Security
Comments