Cisco (350-601-DCCOR) Exam Questions And Answers page 30
Refer to the exhibit. Cisco Fabric Services is enabled in the network. Which type of IP address is used by the Cisco Fabric Services protocol?
Network Virtualization
Orchestration and Management
An engineer must configure a Nexus 7000 series switch for HSRP on VLAN 100. When fully functional, the router must be the active master. Which set of commands must be used to implement the scenario?
Network Virtualization
Security
Refer to the exhibit.
A network engineer is setting up a multihomed OTV network. The first site has been set up with a primary and secondary adjacency server.
Which configuration must be added on the remote OTV AEDs site?
A network engineer is setting up a multihomed OTV network. The first site has been set up with a primary and secondary adjacency server.
Which configuration must be added on the remote OTV AEDs site?
Network Virtualization
Security
Which statement describes the rolling EPLD upgrade on a Cisco MDS 9000 Series Switch?
Network Virtualization
Storage Networking
Refer to the exhibit. A network engineer created a new role to be assigned to the SAN users. The requirement is for users to have these characteristics:
" permitted to show access to the system, SNMP, module, and hardware information.
" permitted to run debug zone and exec fcping commands.
" restricted from accessing show feature environment command.
Which configuration set meets these requirements?
Storage Networking
Security
A network engineer must configure a power redundancy policy on a Cisco UCS C-Series Rack Server. The power redundancy must support two power sources being used to power the server. Which configuration should be applied to meet the requirement?
Network Virtualization
Compute
An engineer must create an EPG called "Test". The configuration request should succeed if the Tenant called "Tenant" and the application profile called "Test" exist. The firewall policy allows only the HTTP connectivity to APIC from the user s computer. Which action accomplishes this goal?
Network Virtualization
Security
Port security is enabled on a Cisco MDS 9000 Series Switch.
Which statement is true?
Which statement is true?
Storage Networking
Security
An engineer is configuring a backup operation on the existing Cisco UCS environment using a logical configuration.
Which configuration is expected to be saved by using this backup type?
Which configuration is expected to be saved by using this backup type?
Compute
Automation
A storage array must be connected to port ethernet1/10 on a Cisco MDS 9000 Series Switch. In addition, the array must connect using the FCoE protocol and be single-homed. Which configuration meets these requirements?
Storage Networking
Security
Comments