Exam Logo

Cisco (350-601-DCCOR) Exam Questions And Answers page 6

After a Cisco Nexus 7000 Series Switch chassis replacement, the administrator discovers that all vPC-enabled LACP port channels are reinitialized. The administrator wants to prevent this issue the next time the chassis is replaced. Which two actions must be taken to meet this requirement before the isolated device is reloaded? (Choose two.)
Network Virtualization Security
A Cisco MDS 9000 Series Switch is configured for SAN Analytics and SAN Telemetry Streaming. An engineer must enable analytics for NVMe on interfaces in the range of fc1/1-12. Due to a large amount of traffic generated in the SAN environment, the data must be collected at regular intervals of 60 seconds from ports fc1/1-12 and then for ports fc1/13-24 for the next 60 seconds. Ports in the range fc1/13-24 were already enabled for analytics. Which set of commands must be used to meet these requirements?
Storage Networking Security
An environment consists of a Cisco MDS 9000 Series Switch that uses port channels. An engineer must ensure that frames between the source and the destination follow the same links for a specific flow. Subsequent flows are allowed to use a different link. Which load balancing method should be used to accomplish this goal?
Network Virtualization Storage Networking
Refer to the exhibit.

What is the reason the system-fm-vrrp checkpoint was created?
Network Virtualization Security

Refer to the exhibit. An engineer is configuring a VSAN on the network. Which option must be selected to create the VSAN?
Network Virtualization Storage Networking
An engineer needs to monitor ingress traffic that arrives at interface Ethernet 1/3 that belongs to a Cisco Nexus 5600 Series Switch. The traffic analyzer machine located at interface Ethernet 1/5 is already monitoring other production, and the traffic analyzer must not be impacted by the traffic captured from the interface Eth1/3. The operations team allocated a traffic budget for the new monitoring session of 1 Gbps to meet this requirement. Which set of commands configures the SPAN session?
Network Virtualization Security
An engineer must implement a disaster recovery policy for the Cisco UCS infrastructure. The solution must meet these criteria:
• The Recovery Point Objective must be 48 hours.
• The backup must use encrypted transmission.
• The Recovery Time Objective must be 4 hours.

Which configuration set must be used in the scheduled backup to meet these requirements?
Compute Security
A network engineer is configuring the Cisco UCS service profile template with Ansible using this code:

username: cisco
password: f718c4329405726531f6247ff982
name: DCE-CTRL
template_type: updating-template
uuid_pool: UUID-POOL
storage_pronte: DCE-StgProf
maintenance_policy: default
server_pool: Container-Pool
host_firmware_package: 4.1(1a)
bios_policy: Docker

Which attribute must be used to apply the iSCSI initiator identifiers to all iSCSI vNICs for the service profiles derived from the service template?
Network Virtualization Automation
An engineer must perform a software upgrade on a production Cisco Nexus 7000 Series Switch. Before the upgrade activity, the requirement is for all ports to be shut down and routing protocols to terminate gracefully. Which feature must be used to meet these requirements?
Network Virtualization Security

Refer to the exhibit. An engineer must distribute all the host ports to use all eight configured FEX uplinks. The solution must minimize disruption if an uplink fails. Which action accomplishes this objective?
Network Virtualization Compute